MAKITA Kit MK403 (DHP481 + DHR243 + DGA504 + DTD154 + 2 x 5,0 Ah + DC18RC + LXT600)

MAKITA Kit MK403

Hammer Drill MAKITA DHP481

• - BL Brushless motor : more efficient, reduces friction and motor overheating thus increasing battery life
• - Two mechanical speeds and variable trigger speed for greater precision at the beginning of drilling and screwing
• - 21 tightening torque positions : up to 10 Nm in position 21
• - Self-locking chuck, a single action that makes it easy to change accessories
• - High-brightness LEDs perfect for spaces with reduced visibility
• - Longer grip, allows for a firmer grip on jobs that require a high torque

Hammer MAKITA DHR243

• - BL brushless motor: the energy produced by the motor is more efficient, increases the productivity of the hammer
• - Three working modes: drill for wood and metal, drill + hammer for stone, concrete and hammer for small demolitions
• - 18V hammer with vertical motor: designed for the most demanding jobs
• - Safety clutch that protects the motor from accidental bit engagement
• - Model with the possibility of changing to an automatic chuck
• - Possibility of fitting the new DX01 and DX02 suction adapters
• - Ergonomic soft grip handle for better grip

Mini-Grinder MAKITA DGA504

• - 18V Mini-Grinder with brushless BL motor, better performance than the previous model (DGA452)
• - Equipped with automatic speed control. Change the cutting speed depending on the work you do :
•       + Light work : high speed mode
•       + Demanding jobs : high torque mode
• - Anti-restart system that prevents accidental start-up of the tool, thus avoiding possible accidents
• - Soft start that prevents jerking in the start
• - Indicator of the state of the load in 3 stages :
•       + 3 lights : more than 50% of the load
•       + 2 lights : between 50 and 20% of the load
•       + 1 light : less than 20%
• - Battery protection circuit that protects it from damage due to overload, temperature or over discharge
• - XPT technology that protects the tool in outdoor work
• - Suction filters placed in the suction sockets to prevent dirt from entering the tool

Impact Driver MAKITA DTD154

• - 18V Impact Driver with brushless BL motor
• - Three screw speeds : Hard, Medium, and Soft
• - Special “T” mode for self-drilling screws, the speed drops to Medium just when the impact enters, allowing to drill first and then screw continuously
• - Variable speed on the trigger with reversible mode, allows us to regulate screwing speed as required by the work
• - Ergonomic anti-slip grip, covered with elastomer, the handle fits perfectly in the hand for comfort and control
• - Lighter and more compact design with 117 mm length allowing work in places with difficult access
• - LED light to illuminate the work point in low light areas. The LED stays lit a few seconds after the trigger is pressed. It can be deactivated by pressing and holding “T” mode